Keep clean with mild soap and water, do not use silicone based cleaners or treatments.
Do not scrape or drag cover.
Do not use vapor seals to lift or remove cover (pouches at inside ends of hinge area).
Do not lift cover without unfastening locking straps.
Keep water and snow off top of cover.
Do not walk, sit or lean on cover.
Attach all locking hold down straps when installing and fasten when not in use to prevent heat loss.
Use handles and straps for positioning only, seams will not support the weight of cover.
Inner Core Maintenance
Important: Excess chemicals and/or chemical imbalance will deteriorate the plastic vapor barrier. When vapor barrier is damaged, inner cores will absorb moisture. The following instructions will prolong the life of your plastic vapor barrier and inner cores.
Be sure to take the cover completely off the tub when shocking with chemicals and leave it off for a period of 30 minutes or until the chemical level is back to normal. Very important to take cover off, not just flip one side open.
Spray or wipe off the bottom side of your cover approximately once a month to get the excess chemical residue off the plastic barrier. These excess chemicals are what cause the plastic to dry out and crack.
Approximately every 6 months, take the inserts out and flip them over so that the opposite side of the insert is over the water.
Warning Avoid Drowning Risk
STAY OFF COVER - WILL NOT SUPPORT WEIGHT.
KEEP CHILDREN AWAY - CHILDREN OR OBJECTS CANNOT BE SEEN UNDER COVER.
REMOVE STANDING WATER - CHILD CAN DROWN ON TOP OF COVER.
REMOVE COVER COMPLETELY BEFORE ENTRY OF BATHERS - ENTRAPMENT POSSIBLE.
NON-SECURED OR IMPROPERLY SECURED COVERS ARE A HAZARD.
CHECK COVER FREQUENTLY FOR DAMAGE AND/OR PREMATURE DETERIORATION.
FAILURE TO FOLLOW ALL INSTRUCTIONS MAY RESULT IN INJURY OR DROWNING.
COVER IS CONSTRUCTED TO MEET THE REQUIREMENTS SPECIFIED IN ASTM F-1346-91.